Call (480) 421-9048

Custom

Jeep

/Jeep

We Service and Repair Most Jeep Cars and Trucks

2012 Jeep Wrangler

2019-12-06T23:01:47+00:00

Jeep Wrangler

Mileage
77,751
Service Date
12/5/2019
Services Performed
  • Conventional Engine Oil & Filter Service
  • Remove & replace Rock Guard to Extract Stripped Bolt
 
Nate V. gave our service a 5 star review on 12/5/2019
2012 Jeep Wrangler 2019-12-06T23:01:47+00:00

2012 Jeep Wrangler

2019-08-07T22:01:30+00:00

Jeep Wrangler

Mileage
75,862
Service Date
8/6/2019
Services Performed
  • TRANSFER CASE FLUID – Drain and Refill – All Applicable Models
  • includes BG Power Clean, contains anti-wear ingredients, antioxidants, and seal conditioners
 
Nate V. gave our service a 5 star review on 8/6/2019
2012 Jeep Wrangler 2019-08-07T22:01:30+00:00

2011 Jeep Wrangler

2018-10-25T22:02:15+00:00

Jeep Wrangler

Mileage
89,969
Service Date
10/24/2018
Services Performed
  • AIR CLEANER ELEMENT – REPLACE ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE IGNITION CABLES/WIRES – REPLACE TRANSMISSION FLUID – REPLACE – [Replace if using the vehicle under any of these conditions: trailer towing, snow plowing, heavy loading, taxi, police, delivery service (commercial service), off-road, desert operation or more than 50% of your driving is at sustained high speeds during hot weather, above 90Deg.F (32Deg.C).] PCV VALVE – REPLACE – [This maintenance is recommended by the manufacturer to the owner, but is not required to maintain emissions warranty.] SPARK PLUGS – REPLACE AXLE FLUID – INSPECT – [Inspect the front and rear axle fluid, change if using your vehicle for police, taxi, fleet, off-road or frequent trailer towing.] BRAKE HOSES and LINES – INSPECT BRAKE LININGS – INSPECT – [Replace if necessary.] CV JOINTS – INSPECT EXHAUST SYSTEM – INSPECT SUSPENSION SYSTEM – INSPECT – [Inspect the front suspension, tie rod ends and boot seals for cracks or leaks and all parts for damage, wear, improper looseness or end play; replace if necessary.] TRANSFER CASE FLUID – INSPECT OIL LIFE SYSTEM – RESET – [To reset the oil change indicator system (after performing the scheduled maintenance) Turn the ignition switch to the "ON" position. Do not start the engine. Fully press the accelerator pedal slowly three times within ten seconds. Turn the ignition switch to the "LOCK" position. If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.] PARKING BRAKE – ADJUST – [Adjust parking brake on vehicles equipped with four-wheel disc brakes.] TIRES – ROTATE
  • FOG LAMP BULB – Remove and Replace – Both Sides
 
Matthew T. gave our service a 5 star review on 10/24/2018
2011 Jeep Wrangler 2018-10-25T22:02:15+00:00

2013 Jeep Wrangler

2018-10-09T22:00:48+00:00

Jeep Wrangler

Mileage
16,356
Service Date
10/8/2018
Services Performed
  • Wire in Flood/Spot Lights to Switch
 
Danilo S. gave our service a 5 star review on 10/8/2018
2013 Jeep Wrangler 2018-10-09T22:00:48+00:00

2012 Jeep Wrangler

2018-01-26T01:03:46+00:00

Jeep Wrangler

Mileage
55,086
Service Date
11/2/2017
Services Performed
  • DISC ROTOR – Remove and Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing. Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
  • AXLE SHAFT SEAL – Remove and Replace – Driver Side
  • DIFFERENTIAL HOUSING COVER and /OR GASKET – Remove and Replace – All Applicable Models
 
Phil S. gave our service a 5 star review on 11/4/2017
2012 Jeep Wrangler 2018-01-26T01:03:46+00:00