Chrysler

Home / Chrysler

We Service and Repair all Chrysler cars

  • 2007 Chrysler Aspen

    Chrysler Aspen
    Mileage
    203,223
    Service Date
    9/27/2023
    Services Performed
    • – Tech found poor contacts on positive battery terminal connector. Performed a battery service (cleaned, installed terminal protectors and used protectant on connectors). –
    • Full Synthetic Oil & Filter Service
     
    Trevor H. gave our service a 5 star review on 9/28/2023
  • 2008 Chrysler Crossfire

    Chrysler Crossfire
    Mileage
    23,869
    Service Date
    1/3/2023
    Services Performed
    • – Tech found 8 codes in the electronic stability program. 7 of these codes have a high likelihood of needing a re-calibration. The final codes may be a master cylinder or a failed module. Tech found that the brake pedal falls to the floor (safety issue). Because this vehicle is a cross between Chrysler/Mercedes there is no repair data or functions for this system in the scan tool. Although we have not had any issues in other vehicle systems, this has left us unable to diagnosis or re-calibrate as needed. –
    • INSPECTION/DIAGNOSTIC FOR CUSTOMER CONCERN(S): Tire pressure light on
    • European/Corvette Engine Oil & Filter Service
     
    Bruce K. gave our service a 5 star review on 1/3/2023
  • 2008 Chrysler 300

    Chrysler 300
    Mileage
    110,110
    Service Date
    3/11/2021
    Services Performed
    • Removed for customer so he could facilitate warranty exchange with SunDevil, and reinstalled prior to inspection and repair
    • This diagnosis was made simply based on customer's photo prior to cars arrival.
     
    Lon G. gave our service a 5 star review on 3/11/2021
  • 2008 Chrysler Crossfire

    Chrysler Crossfire
    Mileage
    76,224
    Service Date
    8/25/2020
    Services Performed
    • 1:Visually inspected secondary air system components(ok) 2: Operated air pump with lap top (ok) 3: Vacuum tested air pump cross over valves 0.15in. hg (ok) 3b: Removed cross over valves and inspected (ok) 4: Applied power to pump and monitored O2 sensors -0.4 volts (ok) 5: Wiggle tested and inspected all connectors and pins. (ok) 6: Removed relay control module, removed housing and inspected solder points and contacts. (bad) Found burnt contact on air-pump relay. Recommend replace
     
    Kenneth F. gave our service a 5 star review on 9/5/2020